The following points should be paid attention to for grinding of non-standard fixture accessories:
1. Abrasive grain size for grinding shall be changed from coarse to fine in sequence. When changing abrasives, the grinding trace of the previous process should be completely removed. Grinding should be carried out until the grinding trace can only be seen this time. It is very important to prevent the “relief” phenomenon by punching the thimble.
2. The abrasive of the same size can only be used for the same grinding tool. Before changing the size, the workpiece must be completely cleaned to prevent coarse abrasive or other dirt from being brought to the next process to form scratch on the grinding surface.
3. Each time the next grain size is changed, the grinding shall be carried out at an angle of 30-45 ° with the last grinding target. If there are deep scars, it is not allowed to only grind the one-sided position, otherwise, the one-sided position will be pitted, and full trimming shall be carried out to remove the pit. It is necessary to pay attention to average grinding for simple grinding and not simple grinding stations
These are the articles shared today. Do you understand? If you want to know more about or need non-standard fixture accessories, please call our company or pay attention to our official website. We will sincerely serve you.
