Share the installation elements of a vacuum pump

The vacuum pump is the basic equipment used to remove the gas in a special sealed container and make the container obtain a certain degree of vacuum. The so-called vacuum refers to a given space, the pressure of less than 101325Pa gas state. Due to the high development of modern science and technology, the application of vacuum pump has spread in all kinds of scientific fields and various enterprises and institutions. Next, the direct rotary vane vacuum pump manufacturer will share with you the installation elements of the vacuum pump.
1, according to the wiring requirements to connect the power and capacitance.
2, strictly prohibit pulling the lead line at random, so as not to cause damage or cause product failure.
3. When the vacuum pump is not in use, adjust the pressure regulating valve to evacuate the air and then cut off the power supply.
4, put the vacuum pump as far as possible in good ventilation, less dust and small humidity.
5. The base is fixed with rubber damping feet or spring minus (environmental protection equipment).
6, the power supply should have sufficient capacity to confirm that the voltage used meets the requirements of the product.
7, the air inlet is connected with the 1/4 joint or other specifications joint and the intake filter muffler and so on.
8, check the vacuum pump components without abnormal, plug the power cord plug into the requirements of the power supply socket (the power socket must be well grounded), the machine starts to work.
9, adjust the pressure regulating valve so that the pressure gauge indicates the required pressure and is stable. (this section needs to cooperate with our PC-3 type plastic vacuum dryer for needle valve regulation) without pressure regulating function of individual vacuum pump.