Ultrasonic cleaning machine for machinery industry parts cleaning: (cleaning attachments: cutting oil, abrasive particles, iron chips, dust, fingerprints)
Removal of rust-proof grease; Cleaning of measuring tools; Removal of oil and rust from mechanical parts; Removal of engine, engine parts, gearbox, shock absorber, bearing bush, nozzle, cylinder block, valve body, carburetor and automobile parts and chassis before painting, removing rust and phosphating; Cleaning of filter, piston fittings, filter screen, etc. Precision mechanical parts, compressor parts, camera parts, bearings, hardware parts, molds and so on.
General methods of ultrasonic cleaning
1. Connect the temperature control sensor signal line, ultrasonic drive line, heater control line and other circuits between the electronic control cabinet and the host computer according to the installation instructions of the ultrasonic cleaner, and connect 380VAC power supply, install the upper water pipe, discharge water pipe and overflow discharge pipe of the cleaner.
2. clean the pond with ultrasonic wave.
Add proper amount of clean water to the cleaning pool, and the height of the liquid level should be as high as immersing the parts to be cleaned, generally not more than three-quarters of the cleaning pool.
3. ultrasonic cleaning heating
Start the electric heating switch and point the white scale line on the water temperature adjusting knob to the appropriate temperature (about 60 C). The maximum temperature of the cleaning agent should not exceed 70 degrees during the use of the washing machine.
4. cleaning agent is added to the ultrasonic cleaner.
When the water temperature rises to about 40, UC-O3 parts cleaning agent is added to the cleaning pool (usually about 5 kg at a time), and the clear water is agitated slowly to dissolve fully (at this time, the ultrasonic wave can be started or the air-blowing device can be opened for stirring).
5. pretreatment of ultrasonic cleaning machine
Before cleaning, it is better to use bamboo knife to clean the dirt on the surface of parts (for example, there will be a lot of dust on the outer surface of the dust shield, and the parts of cylinder block will accumulate a lot of thick and easy-to-remove sludge at the change of the curve of the outer shell) so as to prolong the service life of the cleaning fluid.
Ultrasound can carry out precision cleaning, but its ability to treat mud dirt is weak, so pretreatment should try to remove yellow mud or thin mud dirt.
About the author