In the process of metal stamping production, we often have metal stamping parts crushed or scratched, or when customers come to the workshop to check, they find that the workshop is not clean, which may lead to loss of customers or increase production costs. In order to avoid the discovery of these phenomena, we should pay attention to Hardware stamping parts production planning and formulation of design standards.
Planning of metal stamping production:
1. Strict inspection system should be established in production. The first piece of metal stamping parts produced every day must be thoroughly inspected and put into production only after passing the inspection. At the same time, patrol inspection should be strengthened. If accidents occur, timely handling should be carried out.
2. To ensure the cleanliness of the die cavity in the stamping process, the orderly processed workpieces in the workplace should be placed neatly.
3. Adhere to the civilized production system, such as metal stamping parts and spare parts transmission must use appropriate workstation equipment, otherwise the surface of the workpiece will be crushed and scratched, which will affect the surface quality of the workpiece.
Hardware stamping design standard:
1. In the design of metal stamping parts, it is necessary to ensure that the dimension accuracy and surface roughness are as low as possible in the normal use. It is also necessary to facilitate the interchange between metal stamping parts, reduce waste products and ensure the stability of the quality of metal stamping parts.
2. When designing metal stamping parts, we should use the existing equipment, process equipment and flow to process metal stamping parts as far as possible. At the same time, it should be conducive to prolong the service life of stamping die.
3. The design of stamping parts must be conducive to improving the utilization rate of metal materials, reducing the variety and specifications of materials, and reducing the consumption of materials as much as possible. The low-cost materials should be adopted when permitted so as to make the parts free of waste and less waste arbitration.
About the author