Computer gongs processing patterns, finish is not high. There are many factors. If you are a long shaft type, it may be that the jacking force of the tailstock is not enough, or the tailstock is moving. If the tailstock has no problem, the tool wear, including processing parameters, cutting fluid and other issues, may occur. There is also the material of the part, the corresponding selection tool. In addition, including the problems of the machine tool itself, Dongguan computer gong processing, which can only be solved in practice, there is no way to solve, I hope you can find the reason
The main reason is because of the processing strength problem, it may be that the length of your processing parts is too long, or the length of your cutting tool is too long. The center height of the tool. Choose the right tool. Some are too high speed caused by the machine tool and parts of the resonance of the cutting tool will also appear patterns.
How to improve the finish of lathe processing?
First of all, you should ensure the stability of the lathe, that is, whether the fixed condition of the lathe is good.
What’s more, will the spindle vibrate at high speed,
Secondly, coolant is very important
In addition, your tool should be well ground, and the chip removal groove should be opened to prevent the workpiece from scraping due to unsmooth chip discharge, and the arc angle should be made when the turning tool is chamfered. In addition, when installing the tool, do not resist the tool.
Finally, it is necessary to match the spindle speed and feed speed. If your lathe is not working well, it is recommended to buy some sandpaper to make it. When making sandpaper, it is suggested to deal with it according to the working direction of the turning tool. In this way, the texture can be seen better
About the author