For the quality of processing, it depends on what factors, including many, may be the processing method, may also depend on the material, these are possible, automatic parts processing is the same, then the quality of automatic parts processing depends on what reason?
The quality of the machine depends on the processing quality of the parts and the assembly quality of the machine. The machining quality of the parts includes the machining accuracy and the surface quality of the parts. The machining accuracy refers to the degree to which the actual geometric parameters of the parts are consistent with the ideal geometric parameters. The difference between them is called machining error. The size of machining error reflects the level of machining accuracy. The larger the error is, the lower the machining accuracy is, the smaller the error is, the higher the machining accuracy is; the main factors affecting the machining accuracy are: dimensional accuracy, the conformity between the actual size of the part after processing and the tolerance zone center of the part size.
The machining error of Automatic Parts reflects the machining accuracy. The larger the error is, the lower the machining accuracy is, the smaller the error is, the higher the machining accuracy is; the main factors affecting the machining accuracy are: dimensional accuracy, the conformity between the actual size of the part after processing and the tolerance zone center of the part size. Compared with the method of producing parts with die casting die, it avoids the uneconomical of opening the die when manufacturing small batch parts, and shortens the production cycle greatly. At the same time, the correct clamping and positioning and reasonable processing technology make the processed parts have high precision and surface finish, which is not achieved by die casting process. Moreover, the density of extruded aluminum profile is higher than that of die casting. In addition, this method is different from the general single part machining production, it can batch produce a bed of parts. If the working table of the machine tool is large enough, the bottom plate can be made larger, and several aluminum materials can be arranged at a time, then the processing efficiency can be further improved and the number of tool changes is relatively reduced. If there are features on the side of the part to be processed, such as a round hole to be drilled, then after the part is cut off on the B side, the fixture shall be manufactured, and the part shall be installed
About the author