Vice Clamp installed in machining center

Vice clamp is installed on the working table of machining center

In fact, the installation method of vice clamp is very simple. Firstly, move the vice onto the workbench of the machining center, correct it to the pre-determined position, and then fix the locating block under the Vice Clamp in the T-groove of the working table of the machining center. This method is to prevent the vice clamp from deviated from the position corrected before the re cutting process, and also confirm the vice clamp position The parallelism and verticality of the fixture. This will allow the fixture to be installed.

Key points for installation of workpieces

Just after the vice clamp has been installed, then it will introduce how to install the workpiece on the clamp just now.

1. Before installing the workpiece, the parallelism and verticality of the workpiece shall be confirmed. If the parallelism and verticality are poor, the clamping force after the installation of the workpiece cannot be guaranteed.
2. It is necessary to ensure that the workpiece is installed in the middle of the clamp, and the clamping force of the clamp is consistent with the center of the workpiece, and there will be no offset.
3. Pay attention to not too hard when installing workpiece clamping, otherwise excessive force will cause deformation and poor machining accuracy.
4. The two used gasket must be of the same model. The same type of gasket referred to here is the same size and material of gasket. If the gasket is not the same type, the parallelism and verticality of the workpiece will be poor, which directly affects the processing accuracy of the workpiece.