Machining center is often divided into vertical machining center and horizontal machining center according to the state of the spindle in the space. The vertical machining center whose spindle is vertical in the space is called vertical machining center, and the horizontal machining center whose spindle is horizontal in the space is called horizontal machining center. Spindle can be vertical and horizontal conversion, known as vertical and horizontal machining center or five machining center, also known as composite machining center. According to the number of machining center columns, there are single column type and double column type (gantry type).
According to the coordinate number of machining center movement and the coordinate number of simultaneous control, there are three axis two linkage, three axis three linkage, four axis three linkage, five axis four linkage, six axis five linkage, etc. Three axis and four axis refers to the number of motion coordinates of the machining center. Linkage refers to the number of coordinates that the control system can control at the same time, so as to realize the position and speed control of the tool relative to the workpiece. Machining center is often divided into vertical machining center and horizontal machining center according to the state of the spindle in the space. The vertical machining center whose spindle is vertical in the space is called vertical machining center, and the horizontal machining center whose spindle is horizontal in the space is called horizontal machining center. Spindle can be vertical and horizontal conversion, known as vertical and horizontal machining center or five machining center, also known as composite machining center. According to the number of machining center columns, there are single column type and double column type (gantry type).
According to the coordinate number of machining center movement and the coordinate number of simultaneous control, there are three axis two linkage, three axis three linkage, four axis three linkage, five axis four linkage, six axis five linkage, etc. Three axis and four axis refers to the number of motion coordinates of the machining center. Linkage refers to the number of coordinates that the control system can control at the same time, so as to realize the position and speed control of the tool relative to the workpiece.
About the author