Key points in computer gong processing

Try to install the clamping material first and then the cutting tool, so as to prevent the hand from touching the tool when installing the clamping material. If the tool has been installed, the worktable should first be moved to the outside to ensure that the clamping material will not interfere with the tool, so as to avoid injury or breakage of the tool.
When disassembling the tool, you must first observe whether the spindle stops rotating.
When unloading the knife, do not hold or pinch the edge of the knife with force to avoid scratching.
The wrench should be placed in the tool storage area after use, not on the y-axis shield or beam.
In the process of machining, operators are not allowed to observe the cutting position closely to prevent chips from falling into the eyes.
Before processing, check the position of the oil nozzle before opening the oil pump switch to avoid spraying to other positions when flushing oil.
When the machining gap is suspended for observation, the worktable must be moved away from the cutting position.
Inspection: after the machining is completed and before the workpiece is disassembled, we should first carry out the preliminary inspection of the necessary size or appearance. Only after the inspection is qualified can the workpiece be disassembled, so as to avoid the positioning problem of secondary processing and the scrapping of the workpiece

chengcg administrator