Attention in parts processing

For operators, for their own processing things, we must know how to operate, but also know what the precautions are, so that it is useful for themselves, otherwise, when processing, there will be accidents, Dongguan CNC parts processing is the same, so what problems should be paid attention to in parts processing?

1. It is necessary to follow the safety operation regulations of machining center.
2. Wear protective equipment and cuff before operation. It is forbidden to wear scarf, gloves, tie and apron. The braid of female workers should be tied in the hat.
3. Check whether the tool compensation, zero point of machine tool and workpiece are correct before starting the machine.
4. The relative orientation of each button should meet the operation requirements. Carefully compile and input NC program.

CNC parts processing in Dongguan

1. Check the operation status of protection, insurance, signal, orientation, mechanical transmission part, electrical and hydraulic digital display system on the equipment, and carry out cutting under all normal conditions.
2. Before CNC machining of parts, the machine tool should be run in order to check the operation conditions of smooth, mechanical, electrical, hydraulic and digital display systems. Cutting can be carried out under all normal conditions.
3. After the machine tool enters the processing operation according to the program, the operator is forbidden to contact the workpiece, cutting tool and transmission part of the moving person, and it is forbidden to transfer or take things through the transmission part of the machine tool.
4. It is necessary to park the machine when adjusting the machine tool, clamping the workpiece and cutting tool and wiping the machine tool.
5. Things or other articles are not allowed to be placed on electrical appliances, operation cabinet and protective cover.
6. It is forbidden to remove iron filings directly by hand, and should be cleaned with special tools.

CNC parts processing in Dongguan

1. In case of abnormal conditions and alarm signals, park the vehicle immediately and ask relevant personnel to check.
2. It is forbidden to leave the operation post when the machine tool is running. If it is necessary to leave the machine tool for some reason, put the working table in the central position and return the cutter bar. It is necessary to park the vehicle and cut off the power supply of the main engine.