We all know that no matter what the equipment is, there are many matters needing attention in the operation. The purpose of this is to better ensure our work effect, reduce the occurrence of faults and ensure the quality of products. These matters needing attention are basically easy to ignore in our daily work, but sometimes they cause us some troubles. So the following with the small make-up to understand the hardware processing in the operation must pay attention to what matters?
1、 All employees should check whether their clothes meet the work requirements before entering the work. During operation, it is necessary to concentrate on the operation, and it is strictly prohibited to chat and cooperate with each other. The operator should not operate under the state of irritability and fatigue, so as to avoid accidents and ensure the safety of operation.
2、 Before the machine works, check whether the moving part is filled with lubricating oil, and then start and check whether the clutch and brake are normal, and run the machine tool at idle speed for 1-3 minutes. It is strictly forbidden to operate in case of mechanical failure.
3、 When replacing the mold, the power supply should be turned off first, and the moving Department of the punch should stop running before the mold can be installed and debugged. After installation and adjustment, manually move the flywheel for two times to check whether the upper and lower dies are symmetrical and reasonable, whether the screws are firm, and whether the blank holder ring is in a reasonable position.
4、 Only when all other personnel leave the mechanical working area and take away the sundries on the worktable, can the power supply be started to start the machine.
5、 After the machine is started, one person will transport materials and operate the machine. Other people are not allowed to press the electric building or step on the pedal switch board, nor can they put their hands into the mechanical working area or touch the moving parts of the machine with their hands.
6、 When off duty, the power supply should be turned off and the finished products, leftovers and sundries should be sorted out to ensure the clean and safe working environment.
The above six points are the hardware processing in the operation of the need to pay attention to the matter, although it is some very small matters, when we have achieved the effect is very good, so today’s small editor to talk about here, want to know more information, welcome to visit our website for detailed understanding.
About the author