How to operate sander

How to operate the sander? The following is a detailed description of its operation steps:

1. Operators must be familiar with the performance and use of the machine and operation precautions before operating. Fresh hands are strictly prohibited to operate alone on the machine and non-related personnel must not be near the machine.

2. Operators are not allowed to wear machine-involved clothes, such as loose Necklace clothes and other long hair, please curl their hair, or wear headgear and gloves to operate the machine.

3. The safety device on the sander should not be removed at will, and any non-work objects should not be placed on the worktable, such as wrenches, so as to avoid the damage of the machine caused by foreign bodies.

4. Make sure all switches are in OFF position before switching on the power supply switch. Check the cleaning sharpness of the abrasive belt before normal operation, check the installation direction of the abrasive belt correctly (the arrow on the back of the abrasive belt points to the same direction as the rubber wheel steering), whether the abrasive belt specifications are suitable, whether the abrasive belt swings properly, whether the abrasive belt is loose and conveyed moderately. The track of the belt conveyor is moderate, whether the conveyor belt is tight or not, and whether the blade is properly installed.

Fifth, all the cover must not be removed before processing to determine whether the size of wood within the scope of the machine, adjust the correct thickness of processing, wood too thick will lead to conveyor belt stuck fracture, the equipment can only be used for uniform thickness of wood sanding can not be used for horizontal correction of wood bending, and triangle Neither rhombic nor circular curved wood can be processed. It must be noted that there are no metal accessories on the workpiece to avoid damage to the machine.

6. In the normal operation, please pay attention to the electric load of the ammeter at any time to prevent the occurrence of jumping machine or sandpaper overload, resulting in sand belt cracking or fracture. Correction methods: 1 to slow down the sanding belt; 2 to replace the sanding paper with coarse sand; 3 to rubber wheel or sanding plate position increased a little more to reduce the amount of sanding.

7. When the operator works, once the workpiece is put on the conveyor belt, both hands must leave immediately. The workpiece should be evenly distributed on the conveyor belt. It means that the abrasive belt and the rubber wheel have uniform force, avoid unilateral wear and tear, and shorten the service life of the abrasive belt and the rubber wheel.

Eighth, the sand machine table adjustment using computer digital lift controller operation, table adjustment is strictly prohibited beyond the controller adjustment range, not altruistic manual adjustment table height, in order to avoid table tilt or lift controller data errors, conveyor belt speed adjustment speed using infinitely variable speed to adjust in machine operation.

9. Be sure to clean up the inside of the machine and remove the sandpaper when you clean up the inside, and then install the sandpaper when you finish cleaning up. It is recommended that the abrasive belt be loosened after the work is finished, so that the belt is kept in a tight state for a long time, resulting in gradual relaxation.

10. The new employee must be trained to operate the machine, and the old employee must accompany the work before the employee is fully familiar with the performance of the machine. If the operator wants to leave his job, he must turn off the machine and stop talking with others in the operation.