1.1 In order to implement the policy of “safety first, prevention first”, strengthen safety management, enhance safety awareness, ensure safe production, eliminate people’s unsafe behavior, the unsafe state of things, so that safety production can be followed by rules, there is evidence to follow, this regulation is specially formulated.
1.2 Operators must strictly abide by the relevant provisions of “Safety Management System for Chemical Enterprises” and “Prohibition of Chemical Safety Production”.
1.3 this regulation is applicable to the maintenance personnel of each workshop.
2, operation procedures
2.1 before wearing objects, wear gloves (gloves, respirators and glasses) to prevent splashes from hurting people.
2.2 Cutting machine must be checked before use whether it can be used normally (such as the power cord is damaged, cutting blade is closely related to whether there is damage, etc.).
2.3 When replacing the cutting blade, first turn off the power supply and hang the warning board. The cutting blade must be concentric and tightened so as not to fall off and hurt people.
2.4 the cutting machine must be used in the designated rooms of the workshop, and can not be cut into inflammable and human.
2.4 when starting, check whether the cutting machine is running in the right direction.
2.5 when cutting machine, the object must be clamped.
2.6 when cutting objects, force should be steady. During operation, if the cutting piece is damaged, it must be stopped immediately, and replace the intact cutting piece before running.
2.7 After cutting, first turn off the power supply, when the grinding wheel stop rotating, then take the object, so as to avoid flying cutting blade injury.
About the author